Skip to content
Roll over image to zoom in
Click on image to zoom
- Extremely hard anodized aluminum. Stronger and lighter than equivalent standard cast or billet machined part.
- This is a DIY complete set of aluminum 7mm links for crawlers.
You can custom build aluminum links using this set. There are enough material to build virtually any 1/10 sized crawler.
5x Aluminum outer rods 240mm X 7mm?á
5x All Thread inner rods 250mm X 4mm
18x M4 Nylon (Straight) Rod Ends (18.5mm)
2x M4 Nylon (Sideways) Rod Ends (19.5mm)
20x Steel Pivot Ball (5.8x3x7.4mm)?á
All you need is carefully figure out how long your links are, then cut them up to the specific sizes.
You can build front upper links,?á front lower links, rear upper links, rear lower links, steering tie rod and drag link.
They are bendable and can be made into high clearance links by bending the aluminum rods on a vice.
The upward rod ends are intended for the steering tie rod link to clear the diff cover.
This complete DIY kit has approximately 1500mm total build length.